Janome DC 3018 Service Manual

27, SETSCREW (B) MACHINE SOCKET REPLACING MACHINE SOCKET (UNIT) SETSCREW (B) REPLACING THE MACHINE SOCKET TO REMOVE: 1. REMOVE THE FRONT AND REAR COVER (SEE PAGE 6 ~ 8). 2. REMOVE THE TWO SCREWS AND REMOVE THE MACHINE SOCKET. TO INSTALL: 3. TO INSTALL THE MACHINE SOCKET, FOLLOW THE ABOVE…

19, Janome DC 3018 MECHANICAL ADJUSTMENT THREAD (POLYESTER SEWING THREAD (#50 WHITE)) @ PULL THE THREAD AT A SPEED OF APPROX. 110 MM/SEC. IN THE DIRECTION OF ARROW. SHAFT THE STANDARD TENSION SHOULD BE 75 TO 90 GRAMS WHEN THE TENSION DIAL IS SET AT "A" (AUTO), MEASURED WITH A #50 WHITE …

9, SERVICE ACCESS (3-2) FRONT COVER FEED BALANCE DIAL KNOB MACHINE PLUG SETSCREW (F) SETSCREW (G) Hook 1. UNFASTEN THE FRONT AND REAR COVER HOOKS AND THE BOTTOM SIDE HOOK AS SHOWN. 2. PULL THE FRONT COVER TO CLEAR OF THE FEED BALANCING KNOB. 3. PULL THE FRONT COVER TO CLEAR OF THE MACHINE SOCKET …

8, SERVICE ACCESS (3-1) SETSCREW (C) SETSCREW (B) SETSCREW (A) SETSCREW (F) SETSCREW (E) SETSCREW (D) FRONT COVER SETSCREW (G) MACHINE SOCKET (CONNECTOR ON THE PCB) POWER TRANSFORMER (CONNECTOR ON THE PCB) SETSCREW (H) TO REMOVE: 1. REMOVE THE FACE COVER AND BED COVER (SEE PAGES 7 AND 8). …

17, MECHANICAL ADJUSTMENT THE HIGHEST POSITION OF THE FEED DOG SHOULD BE BETWEEN 0.8 TO 0.9 MM FROM THE SURFACE OF THE NEEDLE PLATE WHEN THE PRESSURE DIAL IS SET AT "3" AND THE PRESSER FOOT IS RAISED. 1. SET THE PRESSURE DIAL AT "3" AND LOWER THE PRESSER FOOT. 2. TURN ON TH…

21, MECHANICAL ADJUSTMENT THREADER KNOB HOOK NEEDLE HOLE REPLACING THE NEEDLE THREADER COVER (WITH THE THREADER PLATE ATTACHED THREADER PLATE SUPPORTER (A) FIG. 1 VERTICAL ADJUSTMENT THREADER POSITION SET PLATE FIG. 3 FIG. 2 X PIN (B) SETSCREW (D) j 1. PUSH DOWN THE NEEDLE THREADER KNOB AND P…