Janome MyStyle 100 Service Manual

6, 4 SERVICE ACCESS FACE COVER TO REMOVE: 1. REMOVE THE SETSCREWS (A). 2. TAKE THE FACE COVER (B) OFF. TO ATTACH: 1. FOLLOW THE ABOVE PROCEDURE IN REVERSE. (B) (A) …

3, Janome MyStyle 100 1 What to Do When Condition Cause How to fix Reference 1. SKipped 1. Needle is not inserted Insert the needle properly. stitches properly. 2. Needle is bent or worn. Change the needle. 3. Incorrectly threaded. Rethread. 4. Needle or thread are Use the recommended inappropriate for sewing needle…

10, 8 MECHANICAL ADJUSTMENT PRESSER BAR HEIGHT AND ALIGNMENT TO CHECK: 1. RAISE THE PRESSER FOOT LIFTER (A). 2. THE DISTANCE BETWEEN THE PRESSER FOOT (D) AND THE NEEDLE PLATE (E) SHOULD BE 6.0MM (0.24"). ADJUSTMENT PROCEDURE: 1. REMOVE THE FACE COVER. (SEE PAGE 4.) 2. REMOVE THE SCREWS (B) AN…

7, 5 SERVICE ACCESS FRONT COVER (B) DIALS CAP (C) (E) (G) (F) TO REMOVE 1. REMOVE THE FACE COVER (SEE PAGE 4), AND EXTENSION TABLE. REMOVE THE CAP, SETSCREWS (B), (D), (E), (F), (G) AND DIALS. LOOSEN THE SETSCREW (A), (C). REMOVE THE FRONT COVER. TO ATTACH 2. FOLLOW THE ABOVE PROCEDURE IN R…

22, 20 300g LOAD DEFLECTION 7–9 MM (A) (B) MECHANICAL ADJUSTMENT MOTOR BELT TENSION TO CHECK: 1. IF THE MOTOR BELT TENSION IS TOO TIGHT OR TOO LOOSE, IT CAN CAUSE A BELT NOISE: IF THE TENSION IS TOO TIGHT, IT CAN CAUSE THE MACHINE TO RUN SLOWLY AND THE MOTOR TO OVERLOAD; IF THE TENSION IS TO…