Judo i-soft Installation And Operating Instructions Manual

17, Judo i-soft JUDO i-soft 17 Operation If the calculated overall sodium concentra- tion exceeds the values permitted by local the drinking-water regulations, it can be corrected by increasing residual hardness. Based on raw water hardness and the resi- dual water setting, the electronics unit checks the sodi…

27, JUDO i-soft 27 Data sheet Max. possible short term quantity continuously drawn off depending on the raw water hard- ness and a mixed water hardness of approx. 10 °e . Fig. 15: Max. possible short term quantity continuously drawn off Wastewater quantity related to 1 m³ of mixed wa…

9, JUDO i-soft 9 Installation 4.1.1 Requirements for the place of installation The room where the unit is installed must be dry and frost-free! Unauthorised persons must not have access to the softener! ATTENTION (see chapter “Safety information and dangers due to non-compliance”) �…

26, 26 JUDO i-soft Data sheet 9.3 Diagrams Pressure loss in normal operating position (pos. 1) with a raw water hardness of 25 °e and a mixed water hardness of 10 °e depending on the volumetric flow rate. Fig. 13: Pressure loss in normal operating position Max. possible quantity drawn off daily depend…

16, 16 JUDO i-soft Operation 5.1.1 Setting the residual hardness The residual hardness default of the water softener is set to 8 °e. To change the resid- ual hardness setting, press the desired key (see table) for 3 seconds (this can only be done when in operating mode). The read- justed res…