JUKI LH-1152-5 Manual, Instruction Book

7, 26. AMOUNT OF THREAD TAKEN UP BY THE LEVER Reduced Increased The amount of thread taken up by the thread take-up lever must be reduced when light weight fabrics are sewn; raise thread guide O. Inversely, lower thread guide O when medium or heavy-weight fabrics are sewn. Note that the G spec…

8, 32. POSITION OF THE WIPER Needle 2 mm 1. Align red marker spot ® engraved on the arm \vith white marker spot 0 engraved on the handwheel. 2. Move red 0 in the arrowed direction and perform adjustment using adjusting screw 0 so that a clearance of2 mm is provided between the needle and wip…

5, 15. THREAD TENSION Increase iReduce I ncrease Reduce ♦ Needle thread tension Turn thread tension nut No. 2 ® clockwise to increase or counterclockwise to reduce the needle thread tension. Turn thread tension nut No. 1 ® clockwise to increase or counterclockwise to reduce the length of the thr…

10, JUKI LH-1152-5 36. WINDING THE BOBBINS (TWIN BOBBIN WINDER) CSPEGIAL ORDER] 11 1 Take the thread end from a thread spool, pass it through the thread guides Q , @ and @ in that order for an inside bobbin or the thread guides (D , (i and for an outside bobbin and wind it several turns round the bobbin. …

4, 10. TWIST OF SEWING THREAD S twist twist It is advisable to use the left-twist thread (S twist) for the needle on the left and the right-twist thread (Z twist) for the needle on the right. If it is not possible, use only the right-twist thread (Z twist). Either twist will do for the bobbin…

9, 35. GAUGE SETS * Table of gauge sets Needle gauge inch mm IX 31.8 S"specification A specification G specification C specification Needle gauge (For 4mm long stitch) Throat plate 2 Q (For "C specification) (For 6mm long stitch) Presser foot (Forked top) ('Locomobile^…