Kanto OASIS Operation & User’s Manual

2, Introduction Table of Contents Table of Contents / Introduction . . . . . . . . . . . . . 2 Supplied Parts & Hardware ..................3 Setup - Step 1............................4 Setup - Step 2............................5 Setup - Step 3............................6 Setup - Steps 4 to …

6, 6 Step 3: Attach Rear Support Frame and Rubber Bumpers Step 3.1 Position Rear Support Frame. The Rear Support Frame (G) has five sets of captive nuts on the front, and only two sets of captive nuts on the rear, as shown in Diagram C. Position the Rear Support Frame (G) facing front, as…

3, Supporting your digital lifestyle ™ Supplied Parts and Hardware 3 • Phillips screwdriver Required Tools L: Middle and Bottom Glass (6mm) H: Top Frame D: 4mm Allen Key K: Top Glass (8mm) E: Rounded Wood Ends F: Backing Board G: Rear Support Frame x2 x2 A: M6 x 32mm He…

5, Supporting your digital lifestyle ™Supporting your digital lifestyle ™ 5 Step 2: Attach Backing Board to Frames Step 2.1 Position Backing Board. Position the Backing Board (F) against the back of the Oasis TV Stand, oriented as shown in Diagram B. Step 2.2 Start All Six Bolts. St…

4, Kanto OASIS 4 Step 1: Attach Metal Frames to Wood Ends Step 1.1 Attach Bottom Frame Loosely Stand the wooden ends up, and position the bottom frame (J) to align the holes with the inset nuts on one wooden end (E). Insert two M6 x 32mm bolts (A) through the frame’s holes and tighten approximate…

8, www.kantoav.com [email protected] Tel 604.231.9574 Fax 604.231.9535 Limited Warranty To Original Purchaser Kanto AV Systems (Kanto) warrants the equipment it manufactures to be free from defects in material and workmanship for the following limited warranty period of: 24 …