Keba KeContact P20 Installation Manual

41, Keba KeContact P20 Additional technical instructions 41/44 Interfaces Enable input [X1]: Enable input for external authorization: Connection line: - Cross section (min.-max): 0.08 – 4 mm² - AWG (min.-max): 28 – 12 Potential-free switch contact output [X2]: Safety extra-low voltage <50 V AC 50/60 Hz External …

35, Installation 35/44 4.7.2 Safety checks Before the initial use, check the effectiveness of the safety measure(s) of the system according to the nation- ally applicable regulations (e.g.:ÖVE/ÖNORM E8001-6-61, DIN VDE 0100-600:2008-06 "Checks,...")! Electrical systems or device…

5, Important information 5/44 1 Important information 1.1 Safety information WARNING! ● Electrical hazard! Installation, commissioning and maintenance of the charging station must be per- formed by correctly trained, qualified and authorized electricians (1) who are fully respon- sible for the…

10, Variant overview 10/44 RFID sensor The RFID sensor [R] is used for touchless authoriza- tion of a user with MIFARE cards or tags according to ISO14443. Key switch The key switch [S] is used for authorizing a user with a key. Additional optional equipment ● Network capability ●…

39, Additional technical instructions 39/44 5.4 Dimensions Version with standard socket (Type 2) Figure5-1: Dimensions in millimeters en …

16, Installation 16/44 4.1 Installation requirements ● Before beginning the installation, the installation guidelines must be observed. ● Contact person on-site (for access to the mains disconnector in the electrical distribution panel board). ● The electrical connection (power supply line) must…