SkyLink SA-103A Preliminary Manual

4, - While holding the Learn/Set button on the Wireless External Alarm until all the LEDs turn off. You may release the Learn/Set button when the Learn/Set LED stay on. - Press and hold the Learn/Set button on the Wireless External Alarm for 2 seconds until it emits 2 beeps and all th…

7, Installation (Only applicable to SA-103S) The Wireless External Alarm model SA-103S built-in with a Solar Panel, this solar panel is mounted on the top of the housing to maintain a charge to the rechargeable batteries during the daylight interval. During darkness, an insignificant amoun…

5, 6A – Arm Home Sequence: This setting is used when you wish to secure the area but will be at home and moving around within the armed area. In Arm Home setting, any motion sensor will not respond to any movement. Alarm will sound instantly if any of the sensor (e.g. door/window sensor) is …

6, SkyLink SA-103A - During the Arm Away mode, you will have 30 seconds to leave the premises, this is called the exit delay. When the exit delay expires, the Wireless External Alarm is armed. - If a sensor is triggered while the Wireless External Alarm is armed, such as entering the premises,…

1, Wireless External Alarm Model: SA-103A/SA-103S Preliminary Manual 1. Introduction Congratulations on purchasing the Skylink Wireless External Alarm SA-103 Series. The SA-103 Series provide you with a piercing siren and powerful features yet ease to use. You will find the installation to be …

3, 3C – Learn door/window sensor to the Wireless External Alarm: - Press and hold the Learn button on the Wireless External Alarm for 2 seconds and then release. The Learn/Set LED will flash. - Activate the remote by separating the magnet from the sensor unit. - You will hear 2…