TES TES-1307 Instruction Manual

5, TES TES-1307 (3). Stop recording : (4). Reset datalogger : Note : If “ REC ERASE ” pressed while memory is full, “ ” will display. 7. MODE SETTING MAX MIN AVG ▲: Button for increasing the value of Parameters, increasing the parameter rapid. REL J …

1, Datalogging K/J Thermometer TES-1307 INSTRUCTION MANUAL TES ELECTRICAL ELECTRONIC CORP. 1. SAFETY INFORMATION  Read the following safety information carefully before attempting to operate or service the meter.  Use the meter only as specified in this m…

3, 3. FRONT PANEL DESCRIPTION (1). Display (2). Power ON/OFF & Hold button  Press the button to turn on the thermometer.  If we press the button again, it will to enter the Data Hold mode, the “HOLD” annunciator is displayed. When HOLD mode is selected, the thermometer he…

6, Then pls press REC ERASE (INTV) button to save the set value. While in the set mode, if users intend to escape from the mode and don’t want to save the value, users can press ON HOLD OFF to end it. Note : In the set mode, if users don’t push any button in 30 seconds, …

7, 10. RS-232 INTERFACE, SOFTWARE INSTALLATION and OPERATION  For the detailed instruction, please refer to the content of attached CD-ROM, which has the complete instruction of RS-232 interface, software operation and relevant information.  RS-232 protocol : are enclosed withi…

4,  If we press it again, the meter main display will show T1-T2, and the secondary display will show T1, T2, in circulation. (7). REC/ERASE : Data recording / reset datalogger (8). ℃/℉ : Press this key will change the temperature scale between ℃ …