Thermo Pride Thermo Pace Downflow/Horizontal Furnace Installer's Information Manual

11, Installer’s Information Manual Page 11 8. Move rubber cap from inducer-pan port D (located in lower left-hand corner) to inducer-pan port A (located in top left corner). 9. From parts package, get long condensate hose and two hose clamps. 10. Attach condensate hose and one ho…

6, Page 6 Installer’s Information Manual ATTIC INSTALLATION Line contact is permissible for furnaces installed in horizontal positions. The intersection of furnace top and sides forms a line as shown in Figure 6. This line may be in contact with combustible material. Figu…

20, Page 20 Installer’s Information Manual The furnace and its gas control must be disconnected from gas supply piping system at ground joint union during any pressure testing of the system at test pressures greater than 1/2 psi (14 inches W.C.). The furnace must be isolated from gas supply p…

32, Page 32 Installer’s Information Manual 5. Locate five blower motor wires that feed through casing hem. 6. Label blower motor wires for proper replacement. 7. Disconnect blower motor wires from Fan Timer. See Figure 32. 8. Remove 2 screws holding blower door in place.…

31, Thermo Pride Thermo Pace Downflow/Horizontal Furnace Installer’s Information Manual Page 31 SECTION 22. SETTING BLOWER TIMINGS Heating blower on-delay is fixed at 30 seconds from when main valve opens. It is not adjustable. Heating blower off-delay is adjustable to one of four times: 60, 100, 140 or 180 seconds. Heati…

16, Page 16 Installer’s Information Manual of all appliances installed in the space. For example: a 100,000 Btu/hr furnace and a 40,000 Btu/hr water heater would require a volume of at least 140,000 X 50 ÷ 1,000 or 7,000 cubic feet. ?? "Unusually tight construction" means …