Tamerica TCC-2700 Operating Instructions Manual

13, Switch on the machine Set speed to “1” Switching on the machine and setting Switching on the machine and setting Switching on the machine and setting …

9, Tamerica TCC-2700 Pass film over stable support rod Threading the lower laminating roll Threading the lower laminating roll Threading the lower laminating roll …

14, Insert both ends of the film in-between the upper and lower heat rollers using the threading card (should come with the laminating rolls) Once the film is fed fully through the machine, set lever to “UP” position Setting up the machine Setting up the machine Setting up the m…

5, Upper Mandrill inside the laminating roll Lower Mandrill inside the laminating roll After inserting the upper and lower mandrills into the core of the film, it should look like the pictures shown below …

15, Set temperature to desired heat level and press the heat button At this time, the machine will take a few minutes to heat up At 80 degrees Celsius, you will hear a beep from the machine. This is to let you know that when the temperature reaches 90 degrees, the rollers will start to turn. Pre…

19, Feed the papers to be laminated in between the upper and lower heat rollers, as shown above Gently pull the laminated paper at the back. (if you don’t pull, the laminated paper might attach to the machine and get wrinkled, due to static electricity) Feeding Feeding Feeding …