Team Losi XXX-NT Sport Owner's Manual

51, Team Losi XXX-NT Sport 197 201 190 19 5 187 RADIO INSTALLATION (Continued) 48 Step 33. Attach the throttle linkage to the throttle servo horn by inserting a 2-56 x 1/2" button-head screw (187) through the over-ride slider (195) and into the middle hole in the longer arm of the throttle servo horn (190) fro…

28, 124 54 BAG D (Continued) 25 Step 19. Place the rear shock tower (123) over the rear of the gearbox assembly (82)(83) so that the top holes line up. Place a gold ball stud washer (9) over each of the 4-40 x 1/2" cap-head screws (31). Secure the rear shock tower (123) to the gearbox (82)(…

24, 17 88 2 0 19 29 104 19 20 104 105 BAG C (Continued) 21 Figure 48 Step 65. Thread a 8-32 x 1/8" set screw (105) into each of the two holes in the front of the rear pivot block (104). Thread the set screws (104) into the holes until the ends of the set screws just bottom out…

25, 108 111 106 17 106 107 BAG D 22 Figure 51 Figure 52 Figure 52 Attach the dogbones (107) to the plastic universal yokes (106) by lining up the slot on the dogbone (107) with the groove in the univer- sal yoke (106). Secure the two pieces with a 4-40 x 3/8" cap-head screw (17). Tip: A small am…

34, 14 5 146 148 150 144 146 147 115 114 149 150 114 BAG F 31 Step 1. Inspect the inside of the tires [front (144), rear (145)] for any excess material. If present, trim excess rubber to ensure proper seat- ing of the tires on the wheels [front (147), rear (148)]. *NOTE: Do not set t…

5, 17 15 13 16 14 18 1 4 19 20 1 4 21 BAG A (Continued) 2 Figure 4 Step 8. Insert a 3/32" x 3/16" plastic bushing (13) into the two large, angled holes in the bottom of the front kickplate (14). Insert the other two bushings (13) into the two outer holes in the steering br…