BadgePass NXT5000 Operation & User’s Manual

50, BadgePass NXT5000 21 50 Updating the firmware is a simple operation but one which, if not properly completed, can result in the breakdown of your printer and lamination module. Before any update, please contact your BadgePass reseller for guidance on the advisability or otherwise of carrying out an …

14, 14 NXT5000 Lamination has a reject hopper with capacity for 100 cards maximum (0.76 mm - 30 mil) positioned in front of it. To empty it, you just need to open the reject hopper and remove any cards it contains. BadgePass recommends that you empty it regularly. Reject/rear hopper management …

32, 32 NOTE Recommended cleaning cycle: every 5 routine cleaning cycles. Servicing accessory: special adhesive cleaning card. Take the special adhesive cleaning card and remove the two protective films from the front and the back of the card. Check that there is no film in the laminatio…

43, 43 44 Poor print quality Small blemishes on the card Horizontal white lines Blurred image • The card surface may be dirty. Check that your cards are perfectly clean. Use new cards. • Cleaning roller or print head dirty. Launch a cleaning cycle. • The ribbon is not correctly fitte…

49, 49 Step 3 – Configuring the new print head 1. Power up the printer and check that it is properly connected to a computer on which the printer’s BadgePass Print Center is installed. 2. Under the Maintenance heading of the BadgePass Print Center, click the Change Print Head tab. 3. Enter th…

42, 42 TROUBLESHOOTING Do not attempt to use tools or other items to repair your printer in the event of problems, in case major damage is caused. Printer Problems No printing 1. Check the print driver Check that there is a driver for your printer in the Windows® settings. Check …