Baja WD250U Service Manual

203, Baja WD250U 7. Electric starting system 1) Mount: • Timing chain (1) • Up guide plate (2) CAUTION: Tighten the shaft wire of timing chain to avoid dropping it into the crankcase. 2) Mount: • Washer (1) • Electric Starting gear assy (2) • Woodruff key (3) • Magnets rotor (4) C…

134, Section 10 Troubleshooting If the headlight or taillight is out Check: 1. Safety 4. Lamp switch 2. Battery 5. Coupling of wires 3. Main switch (entire lighing system) • Remove the following parts before starting troublingshooting maintenance 1) Cushion 2) Front luggage…

117, Section 2 Inspect switch (I) Inspect switch Make certain the wire end is on the pocket mul- timeter. If there are any problems replace the switch Pocket multimeter • Turn the multimeter to “O” • Turn the multimeter to “Ωx1” when inspecct- ing the circuit • Turn the …

125, The starting circuit of this vehicle including starting motor, cut-off relay, rear brake switch and neutral switch. If the main switch is in position, the starting motor could be operated only at the following conditions: • Driving device is in the neutral postion (neutral switch is closed…

77, d. Disassemble With a soft hammer lightly tap the main driv- ing gear (1) and remove (with thrust pad (2) and bearing (3)) CAUTION: Remove the main driving gear rst if it is nec- essary to replace the gear. Replace the original bearing thrust pad, do not reuse. e. Disassemble: 1) Oil se…

151, 23. Remove • Main clutch nut (2) CAUTION: Loosen the locking pad (1) before removing the nut, and x the main clutch shoe (3), then remove the nut. 24. Remove • Locking pad (1) • Main clutch shoe unit (2) • Washer (3) • Main clutch housing unit (4) • Washer (5) CAUTION…