SuperStick EXP 42" Plus Owner's Manual

1, EXP 42” Plus Laminator Owner’s Manual MADE IN U.S.A. Part#652821 Laminator.com www.laminator.com …

11, 10 Mounting and Laminating using a SuperStick® Pouch Board: 1. For specific instructions on mounting/laminating with a SuperStick® board, refer to the instruction sheet that is packed with each box of SuperStick® pouch boards. 2. Also, refer to the instruction sheet for information…

8, SuperStick EXP 42" Plus 7 Setting Roller Temperature (See Figure 1 and Figure 2) 1. Press the “SEL” green button 2. Adjust the temperature up or down using the up arrow or the down arrow. 3. Press the “SEL” green button again to activate the temperature. Control Panel ( Left ) Figure 1 ( …

20, 19 Part Number Description line 1 Qty Req'd. 802134 WASHER ½” ID .058 THICK 2 802145 PRESSURE SPRING, 57LBS./IN,.48" 4 802162 COMPRESSION SPRING 7912197 2 802166 PHONLIC BUSH, ROTA ELEC THERMO 4 802171 BUSH 1X1 1/8X1/2 FLANGE …

2, 1 Table of Contents About the Manual.............................................................................................................2 Safety Precautions...........................................................................................................3 Findin…

14, 13 Trouble Shooting Common Examples and Causes of Poor Laminating. A. The film is not bonding to the subject or to itself at the sealed edges Causes: 1. The heat (on either or both of the rollers) is set too low. 2. The film tension is too tight. 3. The bottom roll of film is threa…