AD Boivin SNOW-HAWK 800 HO 2007 Shop Manual

92, REAR SUSPENSION, SHOCKS AND TRACK 12 - 24 EXTENSION PLATE ADJUSTMENT There are two possible positions for the extension plate The tilted position allow the snowhawk to improve its speed and its handling The right position gives better performance on sof…

236, PERIODIC MAINTENANCE 2 - 10 2.8. ELECTRICAL SYSTEM Spark plug Check the general condition of the plug, the colour of its electrodes, carbon deposits, plug gap and possible damage to the gasket A NGK BR9ECS spark plug is recommended. Check the spark plug gap. The suggested gap is 0.45 mm…

87, REAR SUSPENSION, SHOCKS AND TRACK 12 - 19 Insert the shock absorber rod (complete) in the body of the shock absorber. Lightly lubricate the ring seal of the piston with shock absorber oil to make installation easier. Install the ring seal housing near the piston. Check the shock …

201, AD Boivin SNOW-HAWK 800 HO 2007 REWIND STARTER 5 - 6 ◆ CAUTION It is of the utmost importance that the rewind starter spring be lubricated periodically using Molykote PG 54 (P/N 420 899 763). Otherwise, rewind starter component life will be shortened and/or rewind starter will not operate properly under ve…

184, ENGINE (CYLINDERS / HEAD / BASE / EXHAUST) 7 - 30 11. Install a thicker or thinner cylinder/crankcase gasket (refer to Parts Catalogs) in order to obtain the specified combustion chamber volume or the nearest. USED PISTON MEASUREMENT Note the measurement on the piston dome.…

82, REAR SUSPENSION, SHOCKS AND TRACK 12 - 14 After removing the parts, always lay them out in the order in which they were dismantled. ● NOTICE: In general, it is recommended that the lock nut from the shock absorber rod be replaced after the absorber has been reassembled 4…