Adamson S-SERIES Operation & User’s Manual

15, Page 15 2.4 Pin Swap Cable System Conguration A single PLM + amplier can drive up to 8x S10 enclosures, so long as the NL803 Pin Swap Cable (920-0024) is utilized. This cable is marked with red heat shrink to distinguish it from other NL8 links in a user’s inventory. Pins 1 &…

2, Page 2 Declarations Declarations BUILT. STRONG. Directive 2006/95/EC: Low Voltage Directive 973-0003 S10 973-0004 S10i 994-0002 S119 994-0004 S119i Directive 2006/42/EC: Machinery Directive 973-0003 S10 973-0004 S10i 994-0002 S119 994-0004 S119i 930-0020 S-Series Support Frame 930-0024 S-Series In…

16, Page 16 2.4 Pin Swap Cable System Conguration E-Rack to Parallel Parallel to Parallel (Pin Swap Cable) Output to Parallel Output to Parallel P US HP US HP US H P US HP US HP US H Pin Swap Cable Between Box 4 and 5 = Circuits 3 & 4 = Circuits 1 & 2 P US HP US HP US H P US HP…

31, Page 31 3.9 Rigging the S119 S-Series | Rigging The S119 can be rigged in the same array as the S10 without the use of any adapter rigging pieces. Afxing the S-Series Support Frame to the S119 is completed in the same manner as described in section 3.4, by using rigging position…

6, Adamson S-SERIES Page 6 1.0 Introduction 1.1 Overview This manual is designed to give the S-Series user the necessary information to accurately fly or stack S-Series loudspeakers in all the available congurations, as well as the proper deployment and use of S-Series loudspeakers. Safe step by …

20, Page 20 3.1 Rigging Overview For arrays with little to no incline, the S-Series Extender Beam centered will usually provide the best weight dispersion. For arrays with negative incline, the S-Series Extender Beam positioned towards the back of the frame will provide the best wei…