Easymount Cold EM-1400 Instruction Manual

3, Introduction Thank you for purchasing the Easymount laminator. Easymount is a high performance wide format mounting and laminating system with a solid construction built to last. The Easymount is great for mounting prints to boards and applying pressure sensitive laminates as well…

4, Safety Instructions • Please ensure that the voltages of power supply you are using match with rated working voltages before operating the machine • The power supply should be close to the machine for convenient use • The power supply should provide reliable protective earthing co…

12, Set-up To drive the machine press either the forward drive button (left hand arrow) for continuous drive or step button (middle arrow) for the foot switch. The foot switch over rides the magic eye, it is advisable to start the machine with the foot pedal & then press the continuous…

25, Laminating Adjustments Temperature Most pressure sensitive films benefit from around 40°C / 104°F of heat being applied to help elliminate ‘silvering’. If you dont get the desired result with 40°C / 104°F continue adding 5°C / 41°F of heat until you get the finish required. Speed…

8, Unpacking your Easymount UNPACKING THE LAMINATOR Unpacking the laminator... Stand Assembly... Position the laminator on the stand... STAND ASSEMBLY LAMINATOR ON STAND 8 …

27, Easymount Cold EM-1400 Trouble Shooting Problem Film running loose and climbing up onto the take up core. This occurs when there is NO tension added to the film. Solution Firstly, ensure the core collars are TIGHT to the shaft by tightening all 4 screws. Add tension to the film by turning the core collar in the…