Ag Leader Technology 5100 Operation & User’s Manual

43, GPS 5100 Receiver User Guide 37 Configuring the Receiver 4 NMEA settings Three screens (NMEA1, NMEA2, and NMEA3) show what NMEA messages are output from the port. Message types shown in upper case are being output; message types shown in lower case are not. For more information about NMEA …

67, GPS 5100 Receiver User Guide 61 Additional Equipment Interface Requirements B B.3 Third-Party Hardware Table B.3 lists the interface requirements for connecting a GPS 5100 receiver to third-party hardware. Table B.3 Third-party hardware interface requirements Hardware Company Protocol NMEA …

5, GPS 5100 Receiver User Guide v Contents 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Related Information . . . . . . . . …

62, A Specifications 56 GPS 5100 Receiver User Guide A.2 GPS Channels Table A.2 lists the performance characteristics of GPS channels. Connectors 12-pin Deutsch connectors Ports Two connection ports, both of which support RS-232 and CAN Mounting Three holes for 10 mm (0.39 in) bolts Compliance F…

31, Ag Leader Technology 5100 GPS 5100 Receiver User Guide 25 Installing the Receiver 3 35.1 Port A Port A on the receiver has a 12-pin Deutsch DTM connector. For cables, use the mating connector, Deutsch part number DTM06-12SA. Viewed from outside the receiver, the Port A connector is on the left. It is the port…

12, 2 Overview 6 GPS 5100 Receiver User Guide The two connectors (Port A and Port B) can perform the following functions: • accept power • accept TSIP, RTCM, ASCII, and (if enabled) CMR inputs • output RTCM, TSIP, and NMEA messages • output 1 PPS signals • provide support for the…