Energer ENB569DRL Safety And Operating Manual

15, Energer ENB569DRL DRILLING OPERATION Drilling wood 1. For drilling into wood, ensure the selection switch is set to the regular drilling function (drilling mode only). 2. When drilling into soft wood, the drill should be operated at high speed. 3. When drilling into hard wood, the drill should be operated …

6, NOISE INFORMATION Wear hearing protection! Measured sound values determined according to EN 60745. The noise figures quoted are emission levels and are not necessarily safe working levels. Whilst there is a correlation between the emission and exposure levels, this cannot be use…

16, TERMS OF USE When all precautions have been taken and the previous operations were done, you can start working. Always secure the work piece especially if it is small and the sheets. Use the hammer drill suitable for the material. Drilling: In the woods, a burned area indicates an…

7, WARNING! Identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the tri…

13, 4. DUST COLLECTION DEVICE (Fig.5) NOTE: The dust cap is ideal when working overhead (vertically). It protects the user from falling dust which may restrict vision. 1. Before fitting the drill bit, pull the dust cap down the length of the drill bit ensuring …

9, SYMBOLS The symbols shown on the product has great significance for the safe use of the product. yyWxx Manufacturing date code: Year of manufacturing (20yy) and week of manufacturing (Wxx); WARNING - To reduce the risk of injury, user must read…