DFI AD72-SC Operation & User’s Manual

27, Hardware Installation 27 2.8 Jumper Settings for the CNR (AD72-SC) 2-3 On: Secondary 1-2 On: Primary (default) 1 2 3 1 2 3 CNR Settings - Jumper JP11 CNR cards are defined as primary or secondary. Set this jumper according to the type (primary or secondary) of CNR car…

8, Introduction  8 Expansion Slots The AD72-SC system board is equipped with 1 universal AGP slot, 4 dedicated PCI slots and 1 shared PCI/CNR slot. The AD72-SN system board is equipped with 1 universal AGP slot and 5 dedicated PCI slots. AGP is an interface designed to support …

74, 74 ! Award BIOS Setup Utility 3.1.6 PnP/PCI Configurations This section describes configuring the PCI bus system. It covers some very technical items and it is strongly recommended that only experienced users should make any changes to the default settings. Reset Configuration Data …

13,  Introduction 13 Wake-On-LAN The Wake-On-LAN function allows the network to remotely wake up a Soft Power Down (Soft-Off) PC. Your LAN card must support the remote wakeup function. Refer to Wake-On-LAN Connector in chapter 2 and Resume On LAN/Ring (Wake Up Events field) in t…

48, DFI AD72-SC 48 Hardware Installation Important: Lighted LEDs serve as a reminder that you must power-off the system then turn off the power supplys switch or unplug the power cord prior to installing any memory modules or add-in cards. On: Default 3.3VSB Standby Pow…

79, 79 ! Award BIOS Setup Utility Clock By Slight Adjust This field provides several options for selecting the external system bus clock of the CPU. The available options allow you to adjust the CPUs bus clock in 1MHz increment. The default setting is 100. Important: Overcl…