Fei Bao T45 Instruction Manual

9, Rudder and Lower Hatch Apply Aeropoxy carefully into the hinge point holes in the vertical stab trailing edge. Wipe away any excess. Put a small amount on the hinge points installed in the rudder and insert into hinge holes. Make sure you have enough throw for the control horn slot to ju…

5, Horizontal Stabilizers Remove lower hatch and set aside. Slip one large and one thin nylon washer on the stab spar and insert into bearing box. Check for at least 40mm throw as you move stab. Use the minimum number of nylon washers to achieve clearance. Tighten and loosen control…

15, Wings Begin construction on the wing by gluing the flap and aileron hinges into the predrilled holes in the root edge of the wing. Before gluing, insure that you are able to achieve necessary throws, there is adequate separation between flap and aileron, and that the aft edges align. Use …

4, Construction Carefully inspect all components. Check the security of all bolts and nuts. Seal with a small amount of thin CA for extra security. If any of the stab bearing plate bolts are stripped, re-tap holes and replace with 6-32 cap head bolts. Reinforce bearing plate and stab …

1, Fei Bao T45 DISCLAIMER: THIS IS NOT A TOY. This is a high-performance miniature aircraft, capable of high speeds and damage to life, limb, and property. The manufacturer and its distributors cannot control how you assemble this model, what equipment you use to fit it out, or how you fly it, and can…

7, There are several ways to attach the twin stab servos to the ply plate that is pre-installed in the fuse. FB supplies wooden blocks with L brackets, you can buy a commercial side mount, or make your own side mount from ply. I elected to make my own out of ply. Attach your servos (8611A use…