Digifly leonardo Operation & User’s Manual

59, Page 59 9 GLIDE PLOTTER DISPLAY SCREEN  The are 3 main display screens on the Digifly Leonardo: - The Thermal Display screen. - The Glide Compass display screen. - The Glide Plotter display screen.  To switch between these 3 main display screens, press the key. �…

46, Page 46  Routes on the Digifly Leonardo can be managed manually or with an external Windows program running on a PC. 6.18.1 INSERT WAYPOINTS IN AN EMPTY ROUTE  To insert Waypoints in an empty Route, press the key (function “EDIT”). The first Waypoint of the list appears, s…

32, Digifly leonardo Page 32 bottom of the vario.  A polar curve (shown in bold on the figure) is a graph of your glider’s sink rate over its speed range.  The glider’s stall speed is shown by at point S and the glider’s max speed at point T on the graph.  On the graph, you can…

56, Page 56 - Press the arrow keys , to move the graphic cursor to the left or to the right. - Press the key (function “Tim”) to change the time display to chronograph display. …

18, Page 18  To change the data shown in this field, press the , keys to highlight the field you wish to adjust.  As you scroll up or down, the fields that you can customize are highlighted (inverted) and for approximately 3 seconds a description of the data curre…

65, Page 65  6) Click "OK" again. Notice that the device will show up as being on the same COM port that it was before (i.e., COM5), but will show up on the new port if you close the Device Manager and open it again. Problem: The cable is working with the Digifly Vltools bu…