Digisol DG-GS4826S Management Manual

116, Digisol DG-GS4826S C HAPTER 4 | Basic Management Tasks Configuring Support for Jumbo Frames – 116 – Figure 4: General Switch Information CONFIGURING SUPPORT FOR JUMBO FRAMES Use the System > Capability page to configure support for jumbo frames. The switch provides more efficient throughput for lar…

949, C HAPTER 39 | VLAN Commands Configuring Private VLANs – 949 – 3. Use the switchport mode private-vlan command to configure ports as promiscuous (i.e., having access to all ports in the primary VLAN) or host (i.e., community port). 4. Use the switchport private-vlan host-association …

241, – 241 – 11 CLASS OF SERVICE Class of Service (CoS) allows you to specify which data packets have greater precedence when traffic is buffered in the switch due to congestion. This switch supports CoS with eight priority queues for each port. Data packets in a port’s high-priority queue w…

555, C HAPTER 21 | Unicast Routing Configuring the Routing Information Protocol – 555 – u Authentication Type – Specifies the type of authentication required for exchanging RIPv2 protocol messages. (Default: No Authentication) n No Authentication: No authentication is required. n S…

565, C HAPTER 21 | Unicast Routing Configuring the Open Shortest Path First Protocol (Version 2) – 565 – Figure 357: AS Boundary Router u Advertise Default Route 8 – The router can advertise a default external route into the autonomous system (AS). (Options: Not Always, Always; Default:…

838, C HAPTER 31 | Access Control Lists MAC ACLs – 838 – {permit | deny} tagged-802.3 {any | host source | source address-bitmask} {any | host destination | destination address-bitmask} [vid vid vid-bitmask] [time-range time-range-name] no {permit | deny} tagged-802.3 {any | host source | …