Allied Vision Guppy PRO Technical Manual

96, Guppy PRO Technical Manual V4.1.0 96 Description of the data path Building defect pixel data The following flow diagram illustrates the defect pixel correction: Note  While building defect pixel correction data or uploading them from host, the defect pixel correction data are stored …

186, Guppy PRO Technical Manual V4.1.0 186 Configuration of the camera Inquiry register for video frame rate and base address 19Ch V_MODE_INQ (Format_7) Mode_0 [0] Format_7 Mode_0 Mode_1 [1] Format_7 Mode_1 Mode_2 [2] Format_7 Mode_2 Mode_3 [3] Format_7 Mode_3 Mode_4 [4] Format_7 Mode_4 Mode_5 …

155, Guppy PRO Technical Manual V4.1.0 155 Video formats, modes and bandwidth Guppy PRO F-503B / Guppy PRO F-503C F0M2 (120 fps), F0M5 (120 fps), F1M5 (60 fps) are only available with electronic rolling shutter (whereas present in both shutter modes). If using global reset release shutter the cam…

72, Guppy PRO Technical Manual V4.1.0 72 Camera interfaces Output modes PinState 0 switches off the output transistor and produces a low level over the resistor connected from the output to ground. The following diagram illustrates the dependencies of the various output signals. ID …

133, Guppy PRO Technical Manual V4.1.0 133 Controlling image capture Example: Guppy PRO F-031 register value x time base + exposure time offset = exposure time 100 x 20 μs + 71 μs = 2075 μs exposure time The minimum adjustable exposure time set by register is 4 μs.  The real mini- mum exposure t…

215, Allied Vision Guppy PRO Guppy PRO Technical Manual V4.1.0 215 Configuration of the camera The time base IDs 0-9 are in bit [28] to [31]. See Table 132 : Time base ID on page 215. Refer to the following table for code. Default time base is 20 μs: This means that the integration time can be changed in 20 …