Citrix MPX 7500 Quick Start Manual

7, Citrix MPX 7500 Figure 1-5. Connecting a Citrix NetScaler appliance to the network Warning: Connecting multiple network ports to the same switch or VLAN can result in a network loop. Note: By default, the NetScaler MPX appliance is configured to use auto-negotiation. When you install a NetScaler applia…

2, Copyright and Trademark Notice © CITRIX SYSTEMS, INC., 2012. ALL RIGHTS RESERVED. NO PART OF THIS DOCUMENT MAY BE REPRODUCED OR TRANSMITTED IN ANY FORM OR BY ANY MEANS OR USED TO MAKE DERIVATIVE WORK (SUCH AS TRANSLATION, TRANSFORMATION, OR ADAPTATION) WITHOUT THE EXPRESS WRITTEN PERMISSI…

6, w Mount equipment into a rack with sufficient airflow for safe operation. w For a closed or multi-unit rack assembly, the ambient operating temperature of the rack environment may be greater than the ambient temperature of the room. Therefore, consider the lowest and highest operating tem…

11, Specifications MPX 7500/MPX 9500 DC power supply input voltage and current 260 W Maximum power consumption 887 BTU per hour Heat dissipation 23 with one power supply Weight (lbs.) 1U Height EIA 310-D for 19-inch racks Width 21.75 in/ 55 cm Depth 0-40 Operating temperature (degree Celsius) 5%-95%…

10, system user nsroot administrator save ns config reboot Note: For information about deploying a high availability (HA) pair, see the Citrix NetScaler Networking Guide at http://support.citrix.com/article/CTX132369. LCD Keypad Setup To set up the appliance by using the LCD keypad on …

4, Figure 1-1. Citrix NetScalerCommand Center MPX 7500/9500 (8xCu), front panel The following figure shows the front panel of the MPX 7500/9500 (4xSFP+4xCu) appliances. Figure 1-2. Citrix NetScaler MPX 7500/9500 (4xSFP+4xCu), front panel The following figure shows the back panel of the MPX 7500/9…