Competition Electronics Turbo35-GFX Operation & User’s Manual

37, Competition Electronics Turbo35-GFX an ASCII printer. However, because the data is transmitted through a serial port, a device known as a Serial to Parallel converter is necessary in order to make a direct connection between the printer and the T35-GFX. Alternately, the ASCII graph may be captured using a PC, and then sent to th…

24, Figure 11 T35-GFX Front Panel Controls. They are: • START/STOP • MODE • PAGE The MODE Button The T35-GFX display can be advanced from one mode screen to the next by pressing the MODE button. It will move through these modes: • CHARGE • DISCHARGE • CYCLE • MOTOR • D…

4, HOW TO CONTACT COMPETITION ELECTRONICS .................................................................................. 61 4 …

7, Remember to put the alligator clip insulators on the wires before soldering the alligator clips, and make sure they’re far enough away from the solder joint so that they don’t overheat and melt. Powering up the T35-GFX The 14 gage 4 foot long pair of leads on the left side of the T35-GFX are t…

3, WHAT CAN I DO WITH MY T35-GFX? 22 THE MODE BUTTON .............................…

25, You can always tell what MODE you are in by observing the MODE STATUS display in the upper-right-hand corner of the display. They are: • chg mode • dcg mode • cyc mode • mot mode • dat mode • set mode Regardless of what PAGE you are on in a given MODE, pressing the MODE bu…