CalDigit RAID Card Manual, Getting Started

25, CalDigit RAID Card 25A. MacPro 1.6 Remove PCI-Express card(s) Disconnect and remove all PCI-Express card(s) except for your graphics card, lift the latch on the card conector, and pull the card out of the slot. Note each cards slot position in order to put them back in the same order when you ni…

58, 58 (*1)Part # CBMiniSAS-BC SKU# 702101 (for Boot Camp) (*2)Part # CBMiniSAS-4C SKU# 702102 (for PC) (*3)Part # CRCCBBM SKU# 760400 *Optional accessories …

36, 36 A. MacPro Port access cover PCI bracket Latch 1.4 Remove the drive modules Make sure the latch on the back panel is open, and pull out all four drive modules as well as their empty carriers. 1.5 Remove the PCI bracket Loosen the two thumbscrews on the bracket that holds…

39, 39A. MacPro iPass cable 1.9 Disconnect the iPass cable Disconnect the iPass cable from the upper left corner of the main logic board and extend toward the PCI connectors as far as possible. You might need to re-arrange some cable wiring for easy access of the iPass cable. …

43, 43A. MacPro CPU Cover ( b ) (8 Core MacPro) Position the bottom front edge of the cover and then rotate the top back until the magnets snap it into place. 1.14 Install any card(s) that you removed initially into their PCI- Express slots Make sure that each card is properly sea…

53, 53C. Wintel PC 3.2 Turn O󰮏/ Shut Down your computer Turn o󰮏 your computer. Touch the metal on the outside of your MacPro (chassis) while it's still plugged in to discharge any static electricity from your body. 3.3 Open your computer case Remove the side panel. Let…