CAMBRIDGE M-SERIES Technical Manual

67, CAMBRIDGE M-SERIES M-Series Technical Manual 65 Cambridge Engineering, Inc. GAS CONTROL SYSTEMS Maxitrol Series 14 The Maxitrol Series 14 controls electronically modulate the burner input to maintain a selected dis- charge temperature. The discharge temperature is set on the amplifier (AD1014) be…

34, Cambridge Engineering, Inc. 32 M-Series Technical Manual switch in the closed position, and wait 30 seconds to read the manometer. If the reading is greater than 0 inch WC, refer to the Maintenance Instruction Section for information on Gas Valve Cleaning for cleaning the seco…

73, M-Series Technical Manual 71 Cambridge Engineering, Inc. 9. Remove the wire from the “G” terminal of the termi- nal block. (This is to avoid a “Call-for-Fan” signal from the Remote Control Station during the next two steps). 10. Let the damper assembly hang down (suspended by t…

53, M-Series Technical Manual 51 Cambridge Engineering, Inc. ASCO GAS VALVES: SERIES 8214 Disassemble the valve (See page 62) and clean all parts as follows: IMPORTANT If parts are worn or damaged, install a complete ASCO Rebuild Kit. 1. Remove the solenoid enclosure. 2. Remove the …

81, M-Series Technical Manual 79 Cambridge Engineering, Inc. ANSI/ASHRAE/IESNA STANDARD 90.1 Overview Energy efficient, Genuine Cambridge ® direct gas-fired heating equipment can comply with the requirements of ANSI/ASHRAE/IESNA Standard 90.1. Compliance is shown on the Cambridge heater na…