BMC Timemachine Assembly Manual

60, Finishing Assembly – V-Cockpit 4.  Secure Di2 wires and brake housing with (x4) zip ties on to the vertical arms 5.  Cut Slider Covers to match the slider extension length 6.  Fix Slider Covers with small M3 bolt Step 4 Steps 5 & 6 cut …

33, 1 Extension 2 Reach plate fixing bolts 3 Reach plate (optional) 4 Cover plate 5 Slider fixing bolts 6 Extension bracket 7 Extension clamp 8 Extension clamp bolt 9 End plug 10 Slider - short (x2) & long (x2) V-Cockpit Components Slider sub-assembly (right…

37, 1.  Install Sliders into the corresponding Base Bar (R & L) 2.  Place the Spherical and V Washers onto the Slider Fixation Bolts (x2) 3.  Insert the Slider Fixation Bolts through the Base Bar holes and the Slider longholes 4.  Install the Slider Fixing Bolts into the correspon…

36, (a) (b) V-Cockpit Assembly – Base Bar Prepare the Base Bar (R & L) by pre-mounting: 1.  Di2 wires 2.  Brake cable housing Note: Failure to install Di2 wires before brake housing significantly increases the difficulty of this process Orientation Pre-cut len…

66, BMC Timemachine Prepare the Base Bar (R & L) by pre-mounting: 1.  Di2 wires 2.  Brake cable housing Note: Failure to install Di2 wires before brake housing significantly increases difficulty of this process Flat-Cockpit Assembly – Base Bar Pre-cutting the cable housings: …

34, V-Cockpit Assembly – Extension Brackets 1.  Insert the Extension Clamp into the Bracket (once installed, the slider will hold the Extension Clamp in place) 2.  Install the Slider into the Bracket and insert the Slider Fixation Bolts 3.  Tighten up to 12 Nm Step 1 Steps 2 …