CAT 6D16 Service Manual

38, 11-15 11 <M10 Bolts> • After fitting the M14 cylinder head bolts 8, tighten the M10 bolts to the specified torque {34 N·m (3.5 kgf·m) [25.1 lbf·ft]} in the sequence shown. Cylinder head gasket [Removal] CAUTION When removing the cylinder head gasket 11, be careful not to sc…

12, CAT 6D16 In order to determine the condition of the vehicle adequately, attend the vehicle beforehand to find and keep record of the accumulated mileage, operating condition, what the customer's demand is, and other information that may be necessary. Prepare the steps to be taken and per…

2, diesel engine Shop Manual (for industrial use) FOREWORD This Shop Manual is published for the information and guidance of personnel responsible for maintenance of 6D16 diesel engine, and includes procedures for adjustment and maintenance services. We earnestly look forward to seeing that this man…

17, Using male pins Touch the pins directly using test probes. CAUTION Be sure that you do not short circuit the connector pins when you use the test probe because this could damage the internal circuit of the electronic control unit. Connector Inspection Procedures Visual inspection Chec…

8, Terms and Units The terms and units in this manual are defined as follows. ● This service manual contains important cautionary instructions and supplementary information under the following four headings which identify the nature of the instructions and information: DANGER WARNING CAUTION…

24, Hex-head Flange Nut Unit: N·m (kgf·m) [lbf·ft] 00-15 00 Strength 4T classification Standard screw Coarse screw 4 to 6 M6 (0.4 to 0.6) – [3.69 to 5.16] 10 to 15 M8 (1.0 to 1.5) – [2.95 to 4.43] 21 to 30 20 to 28 M10 (2.1 to 3.1) (1.9 to 2.9) [7.38 to 11.1] [28.0 to 39.8] 38 to 54 35 to 51…