Brivis Iceberg Service Manual

6, 285 Issue 1 - Service Manual - Iceberg 1 1.0 Operation Overview In February 2015 Brivis introduced a new style of evaporative cooler called the Brivis Iceberg. The Evaporator Module is where heat transfer through evaporation takes place. The Evaporator Module contains the Iceberg c…

34, 285 Issue 1 - Service Manual - Iceberg 29 10.4.6 Damper blade will not close: • Check that the damper motor assembly is not in a delay period, from a prior Cooler operation. i.e. 2 minute – after the fans are turned off. • Follow check procedures as above for damper bl…

15, 285 Issue 1 - Service Manual - Iceberg 10 4.2 Cooler Operation – Auto Sequence The following sequences are normal operation in Auto mode, with the Networker at a set comfort level, and the room temperature varying according to the Cooler's operation and load conditions. When the Netw…

17, 285 Issue 1 - Service Manual - Iceberg 12 2290 Min Platform & Service Clearance 1750 Min 750 Min Safety Tray 550 600 Min 600 Min 600 Location holes (x6) in “Safety Tray” top hat for “Evaporator Safety Tray Cable tie to secure water supply braid…

37, Brivis Iceberg 285 Issue 1 - Service Manual - Iceberg 32 11.2 Fan Motor will not operate • Check power has 10 amp supply at meter • Turn the fan ON in fan only mode and make sure the motor is not in an operation delay period i.e. damper winter seal open time. �…

8, 285 Issue 1 - Service Manual - Iceberg 3 2.3 Service Control Panel 2.4 Brivis Icecap™ - Components Brivis Icecap™ (Plastic) BAL Icecap™ (Metal) Mesh Screen Note: For installation requirements refer to the Appendi…