Brocade Communications Systems ICX 7450 series Deployment Manual

59, ICX 7250-48 This is a fixed 48-Port RJ45 10/100/1000Mbps Ethernet port platform with EEE. It also has fixed 8x10G SFP+ ports, out of which 4x10F SFP+ can be configured as uplink ports and 4x10F SFP+ can be configured as stacking ports. FIGURE 20 ICX 7250-48 Front and Rear panel ICX…

46, Brocade Communications Systems ICX 7450 series Optics information for the Brocade ICX7750 stacking TABLE 10 Model Front Panel Ports LR4 Optional 40G Module Ports LR4 ICX 7750-26Q 1/2/1, 2, 3,4,5,6 1/3/5 and 1/3/6 ICX 7750-48F 1/2/5 and 1/2/6 1/3/5 and 1/3/6 ICX 7750-48C 1/2/5 and 1/2/6 1/3/5 and 1/3/6 Stack formation method 1: Using St…

24, 10 11 ICX7450-48P cc4e.246d.23b8 11 12 ICX7450-24P cc4e.246d.0520 Do you accept the unit id's (y/n)?: y ICX7450-24 Router#T=5m2.9: Election, was alone --> active, ID=1, pri=128, 12U(1-12), A=u1, nbr#=11 0, reason: u12: port-up, , The period is 25 T=5m6.9: Elec…

16, Once stack switch IDs are accepted, the stack units, except the active controller, reset so that the assigned IDs become effective. By default active unit is assigned priority 128 with secure setup utility. Do you accept the unit id's (y/n)?: y ICX7450-24 Router# TFTP session timed…

69, Steps Summarized steps: • Configure 'stack enable' on the intended active controller unit at configuration level. • Enter 'stack secure setup' on the intended active controller unit at device level. Detailed Steps 1. Connect the units in a stack based on the connection…

51, UNIT 9: ICX7750-32Q Router(config)#stack unit 1 ICX7750-32Q Router(config-unit-1)#stack suggested-id 9 ICX7750-32Q Router(config-unit-1)#stack enable Enable stacking. This unit actively participates in stacking stacking is enable. optical monitoring for stacking ports 1/2/1, 1/2/4 is n…