Areca ARC-5030 Series Operation & User’s Manual

104, VT-100 UTILITY CONFIGURATION 104 5.5.3.1.1.4 Strip Size Arrow Key: Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw Areca Technology Corporation RAID Controller Main Menu Quick Volume/Raid Setup Raid Set Function Volume Set Function Physical Drives Raid System Funct…

38, HARDWARE INSTALLATION 38 2.4 Hot-plug Drive Replacement The RAID subsystem supports the ability of performing a hot-swap drive replacement without powering down the system. A disk can be disconnected, removed, or replaced with a different disk without taking the system off-line. The RAID rebui…

118, VT-100 UTILITY CONFIGURATION 118 ed parity disk drive. To check Volume Set from Raid Set system function, move the cursor bar to the Volume Set Functions menu and select the Check Volume Set item, then press Enter key. The Volume Set Functions menu will show all Raid Set number it…

152, WEB BROWSER-BASED CONFIGURATION 152 The new create volume set allows user to select the Volume name, capacity, RAID level, strip size, SCSI ID/LUN, Cache mode, tag queuing, IDE Data Xfer Mode and IDE Channel/IDE Drive#ID. • Volume Name The default volume name will always appear as Volume …

71, Areca ARC-5030 Series LCD CONFIGURATION MENU 71 Figure 4.8.3.2-2 ARC-6020 4.8.3.3 Modify Volume Set Use this option to modify volume set conguration. To modify volume set attributes from raid set system function, press UP/ DOWN to choose the Modify Volume Set Attribute option. Us- ing UP/DOWN to sel…

28, INTRODUCTION 28 data blocks. 1.7.5 RAID 5 RAID 5 is sometimes called striping with parity at byte level. In RAID 5, the parity information is written to all of the drives in the controllers rather than being concentrated on a dedicated parity disk. If one drive in the syst…