astra telematics AT200 Operation & User’s Manual

14, astra telematics AT200 Note: please refer to the AT200 Installation Guide for installation and calibration guidance relating to the use of IGNM mode 3. STOP Report Delay (STPD) When IGNM is set to zero (see above), the AT200 will determine journey START and STOP events based on movement data fro…

3, Product Overview The AT200 is low-cost vehicle tracking device, housed in a sturdy plastic enclosure. Both GPS and GSM antennas are internal. The AT200 incorporates the very latest technology, including the latest Cortex M3 ARM processor, SIMCom SIM800H Quad Band GSM/GPRS modem with Blue…

7, Interconnections All connections to the AT200 are provided by a single 16-way connector. AT200 Pin Applications and Colour Code Pin Function Wire colour 1 JTMS 2 JTDI 3 RS232-TXD GREEN 4 VIN 7 - 36 VDC RED 5 DIGITAL INPUT 1…

1, AT200 Vehicle Tracking Device User Guide Version: 1.3 Date: February 2015 …

8, Electrical Parameters Operating Conditions Parameter Min Max Units Power Supply Input Voltage +7 +36 V Digital Input High Voltage Threshold +5.0 - V Digital Input Low Voltage Threshold - +2.0 V Digital Max…

6, SIM installation The SIM should be inserted in the slot at the rear of the device (with plastic enclosure fitted). The image on the device gives guidance for correct orientation. Note that the AT200 powers up when the SIM is fitted. For shipping with SIM fitted, we suggest extr…