CRP Securities rs2000 Operation & User’s Manual

11, 9 RS2000 DIN The RS2000 comes with a default DIN which is all lower case “rs2000”. This DIN number is needed when pairing a new lock to a smartphone for the rst time as an administrator. LOW BATTERY The RS2000 has a low battery warning function that can be seen everytime a phone is used t…

14, 12 RS2000 EVENTS AND BEEPS EVENTS BEEPS Phone or Card swipe 3 ascending tone beep Low Battery, Successful Unlock 1 beep, 10 beeps for low battery warning Phone or Card Unlock Fail 1 long and 4 short beeps, the long beep tone is higher Low Battery, Unlock Fail 1 long and 4 short beeps, the long …

10, 8 RS2000 USING ONLY RFID AND NO SMARTPHONE In cases where smartphones will not be used to open the lock and only RFID cards, you can use the BATCH mode to ADD and DELETE cards. SET UP BUTTON MODES Push for 1 second ADD users, but ADMINISTRATOR will be DELETED if already setup Push for 5 s…

16, CRP Securities rs2000 14 RS2000 SPECIFICATION COMMUNICATION Type : NFC (Near Field Communication) Radio Frequency : 13.56 Mhz DISCLAIMER: Cal-Royal Products does not claim that this lock can provide complete security by itself. This lock may be defeated by forcible or technical mean…

2, TABLE OF CONTENTS Introduction 1 Key Butler User Manual 7 Requirement 1 Using only RFID card and no smartphone 8 NFC Compatible Smartphone 1 DIN 9 Mifare Compatible Access Cards 1 Low Battery 9 Administrator and Clients 2 Resetting to Factory Default 10 Status LED 3 Events and Beeps 12 Sensor A…

13, 11 RS2000 STEP 3 Replace the battery while pressing the setup button STEP 4 Wait for 4 beeps then release the setup button. The lock will be reset to factory setting and all previously created users and administrator will be removed. Replace the battery cover. …