DAITEM SH271AX Installation Manual

8, 8.2 Changing the battery To change the battery: 1. Switch the control panel to installation mode and ask the master user to press: then The detector’s configuration is saved when the battery is changed. 2. Open the detector casing (see § on Opening). 3. Unclip the lithium …

4, 4 1 2 3 5. Connection Terminal block The terminal block has 3 terminals: • Anti-tamper (1): protection loop terminal (provides protection against external contact wire cutting), • Main (2): main common terminal, • Loop (3): loop connection terminal (supervises opening and cl…

6, 6 • NC surface mounting: contact and magnet to be aligned, levelled (using spacers if necessary), and screw-fixed. • Flush mounting: - drill a hole in the door frame and door 8 mm in diameter and 30 mm deep, - ensure that the contact and magnet are opposite each other, - drill a hole in t…

7, DAITEM SH271AX 7 ))))) 7. Testing The multicontact detector has a “test” mode for testing: • the battery: the LED indicator lamp lights up when the test button is pressed to indicate the battery is working correctly, • detection: the LED indicator lamp lights up when the contacts (built-in or exte…

3, 3 • Example: programming of 1st detector allocated to Group 2 with immediate triggering. IMPORTANT: the control panel indicates an error by emitting 3 short beeps. When this happens programming should be carried out again. 4. Configuration IMPORTANT • The cover must be open when configuring…