ChemInstruments HLCL-1000 Operating Instructions Manual

14, 1. Laminating Pressure Gauge: Displays the line pressure of the laminator. Pressure can be adjusted using the pressure control located directly behind the laminating pressure gauge on the back of the cabinet. 2. Emergency Stop button: Push the emergency stop button to cut off electricity to…

10, MICROMETERS (optional) The micrometers for the HLCL-1000 are optional. The micrometers are mounted on crossbar of the coating head (see diagram under COATING HEAD). The micrometers allow a faster way to set the gap between the top and bottom coating bar. Follow the directions below to use the …

1, CHEMINSTRUMENTS HOT MELT DRAWDOWN COATER MODEL HLCL-1000 OPERATING INSTRUCTIONS PRODUCT DESCRIPTION ..................................................................................................2 UNPACKING ................................................................…

11, BRAKE UNWIND STANDS The HLCL-1000 has two Brake Unwind Stands. One is located to the left of the coating head and the other is located on top of the laminator. The Brake Unwind Stands allow for the substrate you are coating or laminating with to be kept under tension during the co…

4, ChemInstruments HLCL-1000 KEY COMPONENTS 1. Brake unwind stand (pictured with roll of film mounted) 2. Heating controllers 3. Coater ON/OFF switch 4. Coating head 5. Reservoir 6. Laminator controls 7. Laminating nip 8. Alignment guide 9. Alignment guide 1 2 3 4 5 6 7 8 9 4 …

8, 4. Thread the substrate through the coating head in between of the top and bottom coating bar. 5. Move the crossbar up so that the top of the crossbar is level with the uprights. Tighten the top thumbscrews on either side of the crossbar to secure the crossbar. 6. Follow the steps bellow…