DFI G586IPC Operation & User’s Manual

43, 43 Chapter 4 Troubleshooting Checklist If you experience difficulty with the G586IPC system board, please refer to the checklist below. If you still cannot identify the problem, please contact your dealer. 1. Check the jumper settings to ensure that the jumpers are properly set. If in dou…

42, 42 OFFENDING ADDRESS NOT FOUND This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY ERROR messages when the segment that has caused the problem cannot be isolated. OFFENDING SEGMENT This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY ERROR m…

34, 34 Highlight this option on the main menu and press <Enter>. The mes- sage below will appear. Load Setup Defaults (Y/N)? N Type <Y> and press <Enter> to load the Setup default values. PnP Configuration Setup Use the arrow keys to highlight “PnP Configuration Setup”…

28, 28 Use the arrow keys to highlight the option you want and press <Enter>. The following describes each of these options. Standard CMOS Setup Use the arrow keys to highlight “Standard CMOS Setup” and press <Enter>. A screen similar to the one below will appear. Date a…

39, 39 Maximum HDD size: no. Cylinders (1024) x no. Heads ( 32) x no. Sectors ( 63) x bytes per sector ( 512) 1 gigabyte Note: To support LBA or Large mode, address translation software is included in the Award BIOS HDD Sevice Routine (INT13h). If you are running an operating system that …

3, DFI G586IPC Table of Contents Chapter 1: Introduction............................................................ 5 Features and Specifications .................................................. 6 Package Checklist .............................................................. 8 Chapter 2: Hardware …