KVH Industries TracPhone V3IP Installation Manual

31, 30 Dual Dome Configuration The dual dome configuration allows you to connect a second TracPhone V-IP Series antenna as a backup system. Whenever the primary system loses its connection to the mini-VSAT Broadband service, all voice and data traffic will automatically get routed to the second…

18, 17 Connect the RF Cables a. Connect the RF coax cable labeled “RX” to the “Rx RF” jack on the back of the ICM (see Figure 25). Hand-tighten, then tighten with a 7/16" torque wrench set to 20 in.-lbs. b. Connect the RF coax cable labeled “TX” to the “Tx RF” j…

5, 4 Before you begin, consider the following antenna installation guidelines. Choose a Suitable Mounting Surface • Make sure the mounting surface is wide enough to accommodate the antenna’s base (see Figure 2). • Make sure the mounting surface is flat, level (within ±2�…

17, KVH Industries TracPhone V3IP 16 Connect a NMEA 0183 Talker (Optional) A vessel heading input will enhance the system’s performance. A vessel position input will serve as a backup to prevent a loss of service if the antenna’s internal GPS fails. If you want to supply both heading and position to the ICM, you…

3, 2 This icon indicates a danger, warning, or caution notice. Be sure to read these carefully to avoid injury. WARNING Risk of Electric Shock Potentially lethal voltages are present within the ICM when it is connected to AC power. To avoid electric shock, do not open the chassis enclosure. There …

34, 33 Follow these steps to connect the vessel’s phone and any purchased voice line accessories to the system. Connect the Vessel Phone Using the supplied RJ-11 cable, connect the customer’s analog (not digital) phone or PABX to the “Voice Line 1” jack on the ICM (see Figure 58)…