Lionel SD 60/70 Owner's Manual

2, Lionel SD 60/70 2 Table of contents Transformer Operations Running your SD 60/70 with a Lionel transformer 3 Locking your SD 60/70 into a single operational state 4 Using your SD 60/70 Electrocoupler in the non-command environment 4 Installing the Lionel no. 610-5906-001 sound activation button 5 Maintaining a…

7, Note! If you have upgraded your powered locomotive to Command Control, make sure the headlight was not turned off by pressing AUX2 before replacing bulb. 7 Adding fluid to your Locomotive’s smoke generator Y our Locomotive is equipped with a smoke generator that produces safe, clean…

9, 9 Note! Note! Note! Note! Your SD 60/70’s Railsounds system—the basics L ionel Railsounds is the most realistic model railroad sound system in the world. Your SD-60/70 features digital sam- ples from real-life steam locomotives for the ultimate in realism. You may choose to install a 9-…

4, 4 Using your SD 60/70 Electrocoupler in the non-Command environment T o use your SD 60/70 Electrocoupler in the non-Command environment, you must first couple a piece of rolling stock equipped with Lionel magnetic couplers directly to your SD 60/70’s electrocouplers. The magnetic coupler on th…

15, Reprogramming R2LC circuit boards to restore features STEP 1: Move switch on locomotive from run to program. STEP 2: Turn on Command Base. STEP 3: Place locomotive on track, then turn on power to track. STEP 4: Press “ENG” then input locomo- tive’s ID#. Press “SET” STEP 5: Press “ENG�…

3, 3 3 3 Move ‘em out! • Get your SD 60/70 moving. Press the DIR button on your CAB-1 remote or Lionel transformer. This sequences the Lionel reverse unit to the next operating state. • Adjust track voltage until your SD 60/70 moves at your desired speed. To increase speed, incr…