Xinpu XP-R26DA Handling Instructions Manual

13, 4. Hammering only This rotary hammer can be set to hammering only mode by pressing the push button and turning the function knob to the mark. (Fig.8) (1)Mount the bull point or cold chisel. (2)Press the push button and set the function knob to middle of mark and mark.. (Fig.9) …

6, b) Use safety equipment. Always wear eye protection. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. c) Avoid accidental starting. Ensure the switch is in the off position before plugg…

10, Drill bit Core bit (outer diameter) Core bit shank 25mm 29mm (A) 32mm 35mm 38mm Core bit shank(A) Φ8x110mm (B) 45mm 50mm Core bit shank(B) 4. Demolishing operation (hammering only) Bull point (Round type) (SDS-plus shank) + 5. Groove digging and edg…

12, Xinpu XP-R26DA HOW TO USE CAUTION: To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when the drill bits and other various parts are installed or removed. The power switch should also be turned off during a work break and after work. 1. Swi…

15, brush. 6. Service parts list A: Code No. B: Item No. C: Part Describe D: Quantity CAUTION: Repair, modification and inspection of Xinpu Power Tools must be carried out by a Xinpu Authorized Service Center. This Parts List will be helpful it presented with t…