Manual, Installation Instructions for Alarm Lock Trilogy DL1200 Security System (1 pages)
Data: UPD 25th March 2024
Alarm Lock Trilogy DL1200 Security System PDF Installation Instructions (Updated: Monday 25th of March 2024 05:11:06 AM)
Rating: 4.1 (rated by 35 users)
Compatible devices: PDL6100, ALC-8, PL6100, Trilogy PL3000, LEVER SPRING REPLACEMENT KIT Addendum, DL 2700WP, 250, Trilogy DL2800.
Recommended Documentation:
Text Version of Alarm Lock Trilogy DL1200 Security System Manual (Summary of Contents)
(Ocr-Read of Document's Main Page, UPD: 25 March 2024)
DL1200 - DL1300 - PDL1300
NARROW STILE ACCESS LOCKS
ADDENDUM
DESCRIPTION
This addendum is intended to ensure that the
face of the interface cylinder is parallel with the
surface of the door. Use this addendum with
the "DL1200 - DL1300 - PDL1300 Narrow Stile
Mounting and Installation Instructions"
WI1458, pages 4-5, steps 5-5e:
PROCEDURE
Locate the heading entitled "Insert the Inter-
face Cylinder" on page 4 (step 5). After per-
forming step 5e (installing the latch face plate
on page 5), the following additional step is rec-
ommended before installing the lock in step 6:
5f. Verify the face of the interface cylinder
("HW1299") is positioned parallel to the
surface of the door.
With a straight edge flush against the sur-
face of the door as shown in the image be-
low, place a small ruler on the right face of
the interface cylinder to measure the dis-
tance between the face of the interface cyl-
inder and the surface of the door (the right
"gap"). See Fig. 7c below.
5g. Measure the left "gap" with the ruler on the
left face of the interface cylinder, as shown
in Fig 7d, below:
The difference between the right and the
left "gap" distances must not exceed
1/32".
If face of the lock body is not parallel to the
surface of the door and the difference be-
tween the left and right "gap" measure-
ments exceeds 1/32", adjust the position of
the Adams Rite
®
lock body until the face of
the interface cylinder is parallel with the face
of the door.
345 Bayview Avenue
Amityville, New York 11701
For Sales and Repairs 1-800-ALA-LOCK
For Technical Service 1-800-645-9440
Publicly traded on NASDAQ Symbol: NSSC
© ALARM LOCK 2007
WI1626 6/07
Fig. 7c: Measure right "gap": Place a small ruler against the right
side of the interface cylinder.
Straight
Edge
Interface
Cylinder
(HW1299)
Right
"Gap"
Door
Fig. 7d: Measure left "gap": Place a small ruler against the left side of
the interface cylinder.
Straight
Edge
Left
"Gap"
Door
Interface
Cylinder
(HW1299)
Recommended:
xSeries 450 8688, LEG-3000, ProLiant XL250a Gen9, 14” SNARE DRUM
MAESTRO JA-65, SLL TK-C9200UA, WTK5504, DA-100, S3b Sim Secual
-
IGNIS 1000 CONVENTIONAL FIRE DETECTION AND ALARM SYSTEM IGNIS 1240 FIRE DETECTION AND ALARM CONTROL PANEL � ...
Model & Doc Type: Ignis 1000 45
-
Two-Factor Authentication with One-Time PasswordThe BiGuard OTP is a chip-based, 6-digit numeric PIN token to be used in combination with a password for a strong two-factor authentication. This powerful solution provides single password authentication for remote VPN, LAN and web access through ...
Model & Doc Type: OTP 2
-
InstallationManualFor Technical Assistance, please call (800) 638-3600,or visit www.magnadyne.comThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference; and(2) This device must accept any inter ...
Model & Doc Type: M7a 28
-
DA-100 Drive-Alert now with new Zone Control and Alert Tone Selection featuresTHE BASICSA sensor detects any vehicles entering a monitored areaA control panel receives a signal from the sensor and triggers an internal chime with volume controlThe DA-100 allows you to monitor up to three se ...
Model & Doc Type: DA-100 4
Operating Impressions, Questions and Answers:
