Albatron PM266A PRO Operation & User’s Manual

52, PM266A PRO/ PM266A 49 PM266A PRO/ PM266A 49 4. Finally, on the “Advnaced Controls for Mic” screen, check the “Mic2 Select “Front mic_in setup”. ” to complete the …

37, PM266A PRO/ PM266A 34 UR2 Duplex Mode in only one direction at a time. Mode Select” is set to “ASKIR” or “IrDA”. ptions: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled board parallel port. ptions: ECP(default) Extended Capabilities Port. l Port. …

20, PM266A PRO/ PM266A 17 Serial Port Header: COM2 lear CMOS Jumper: JP1 he “Clear CMOS” jumper is used when you cannot boot your system due to some CMOS nfiguration problem such as a forgotten password. This jumper allows you to reset the CMOS 1. Turn off…

44, Albatron PM266A PRO PM266A PRO/ PM266A 41 Exit Menu ave all configuration changes to CMOS (memory) and exit setup. A confirmation message will be xit Without Saving t session and exit setup. A confirmation message will be Save & Exit Setup S displayed before proc…

45, PM266A PRO/ PM266A 42 Chapter 3: Software Setup Software Installation lace the Driver CD into the CD-ROM drive and the Installation Utility will auto-run. You can also unch the Driver CD Installation Utility manually by executing the via.exe program located on the river CD. …

47, PM266A PRO/ PM266A 44 PM266A PRO/ PM266A 44 Problem 4: System only boots from the CD-ROM. The hard disk can be read and applic isk is impossible. ations can be used but FOUND” displays and the system does not allow certain data intrusion or disk f…