MIMAKI UJF-3042HG Daily Care Manual

5, 5 At the end of the daily work 3 Select [normal] by pressing the or key, and press the key. 4 Press the key. • Cleaning is started. • When cleaning is completed, the mode is returned to the local mode. #CLEAN I NG TYPE : no rma l ENTER ENTER …

7, MIMAKI UJF-3042HG At the end of the daily work 7 7 Dip washing liquid into the cleaning swab, and wipe dirt of the wiper nozzle. • Wipe the places shown in the right. 8 Put washing liquid into the dropper, and drop on the caps to fill them. • Fill the washing liquid into the three caps. 9 Replace the front cov…

9, 9 If defective printing does not improve Cleaning of the wiper The wiper sweeps ink stuck on the nozzle of the head. The wiper becomes tainted with ink or dusts during the operation of this machine. In order to keep the head in good condition, clean the wiper frequently. 1 Press the k…

17, Avoiding dripping of ink droplet at printing 17 7 Dip the cleaning swab into the cleaning solution, and clean the side surface of the head. • Do not wipe the nozzle face of the head. It may cause nozzle clogging. • To buy special cleaning swabs, contact a distributor in your…

10, 10 5 Remove the front cover. (1) Push the both ends of the front cover. (2) Pull the cover to the front while opening upward. 6 Dip the washing liquid into the clean- ing swab, and wipe dirt of the wiper nozzle. • Wipe the places shown in the right. • If the dirt of the wiper is heavy, repl…

3, For safe operation 3 Cleaning the table The table is easy to become dirt with lint, paper dust or the like after cutting media. For a conspicuous stain, wipe it off with a soft-hair brush, a dry cloth, a paper towel or the like. • Be sure to clean the slot on the frame of the tabl…