MINOURA GYRO V270 Instruction Manual

1, indoor bicycle trainer GYRO V270 instructions manual Introduction Thank you for purchasing the Minoura GYRO V270 indoor bicycle trainer. The V270 incorporates a new, patent pending Gyro Technology ywheel that by design is 35% more effective than other trainers in its class. The new NEODYMIUM (…

7, 1 2 1 23 Decrease Increase How To Operate Remote Shifter V270 comes with a convenient remote shifter device. By installing it on your handlebar or stem, you can adjust the resistance level without getting off the bike. The remote shifter should be used in conjunction with the gears on y…

4, MINOURA GYRO V270 Placing V270 on Floor Fully open the legs and place on a at and horizontal oor. ! To open the U-Leg, hold the main frame and the rubber cap on the U-Leg. Do NOT pull the Alloy Leg Guide directly, otherwise it will be bent or damaged. Check that all 4 points are touching the oor…

2, How To Assemble U-Leg Required Tools: 2 x 5mm Hex Wrench (supplied) 1 2 5 6 3 7 4 for 700C ~ 29" for 24" ~ 26" Choose the pivot hole for your bike size on the main pillar. Disassemble the pivot bolt. Remove the alloy tube and plastic washers. Insert the alloy tube into t…

8, Schematics UF-1 UF-2 UF-3 UF-4 UF-5 UF-6 UF-7 UF-8 UF-9 UF-10 UF-10 UF-12 UF-11 UF-13 UF-14 UF-15 GM-1 GM-2 GM-3 GM-5 GM-6 GM-7 GM-8 GM-9 GM-10 GM-11 GM-12 GM-13 GM-14 GM-15 GM-4 UF-1 : Main Frame GM-1 : V270 Flywheel UF-2 : U-Leg GM-2 : Alloy Rotor UF-3 : Al…

3, How To Install Mag Unit & Foot Step Required Tools: 1 x 5mm Hex Wrench (supplied) 1 x 10mm Spanner (not supplied) The GYRO Mag unit and Foot Step now need to be attached to the frame. Attach the Foot Step onto the bracket on the Step-Bar rst, put the Mag unit over the Foot …