Casablanca General Owner's Manual

10, 10 Step 1. Remove the knockout plug in the center of the out- let box or drill a 1 /2† hole for the lag screw to pass through. Then drill a 1 /4† guide hole into the joist or beam to a depth of 3 inches. Step 2. Route the outlet box wires through the 1 /2† diameter outer hole o…

16, Casablanca General 16 The Light-Minder program automatically turns OFF the fan mounted lights after two hours. To enter the Light-Minder Program: 1. Turn the OFF for at least three seconds. 2. Turn the ON. 3. Immediately operate the buttons in the following sequence: ++ ++ ++ 4. A series of to…

18, 18 DIP SWITCH SET TO ‘01001’ DIP SWITCH SET TO ‘01110’ NOTE: If this is the second Versa•Touch fan installed in the same area, one of the fans MUST have its channel changed from ‘01110’ or interference will occur. Make sure that the dip switch settings in both the seco…

6, 6 CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket. CROSSBAR MOUNTING BRACKET INSTALLATION CEILING WIRING CROSSBAR MOUNTING BRACKET FLAT WASHER GREEN GROUND WIRE CEILING FAN …

19, 19 + - + - +- REMEMBER THE REMOTE CONTROL WILL GO BACK TO THE ORIGINAL FACTORY ‘PRESET CHAN- NEL’ NUMBER WHEN THE BATTERIES ARE CHANGED. CHANGE CONTROL CHANNEL IF NEC- ESSARY AFTER BATTERY REPLACEMENT. Battery Installation Install three ‘AAA’ alkaline batteries in the sequence show…

13, 13 COLLAR SWITCH HOUSING 3-SPEED ♦ OPTIONAL LIGHT FIXTURE INSTALLATION 3-SPEED ♦ OPERATION Pull-chain switches on the fan control the fan and lights. Using the fan control pull-chain switch: Fan off at start. First pull: fan ON, low speed Second pull: medium speed Third pull: hig…