Alcorn Mcbride Digital Binloop Operation & User’s Manual

58, Alcorn Mcbride Digital Binloop Alcorn McBride Binloop User’s Manual Page 48 Connecting your PC to the Binloop There are two ways in which the Binloop software can interface to the Binloop from your PC: 1. Ethernet 2. RS-232 Serial Connecting with RS-232 Serial If your PC is not equipped with an RS-232 s…

96, Alcorn McBride Binloop User’s Manual Page 86 File Naming A specific file naming convention is used so that the Binloop can identify the file type, as well as associate the file with a number. Here is a table that shows the naming conventions based on the type of file that is being n…

63, Alcorn McBride Binloop User’s Manual Page 53 with the same name and update the saved version with the new information, replacing the old version. If you are using a new file which has not yet been saved, will present the Save window. This window allows you to name your co…

48, Alcorn McBride Binloop User’s Manual Page 38 Mute/Unmute Video Description: This command controls muting on the video outputs of the Binloop. When muted, the video outputs are black. When unmuted, the video outputs display video normally. Command: naaaVD Parameters: …

21, Alcorn McBride Binloop User’s Manual Page 11 Control System The Control system of the controller card is the heart of the Binloop. This system handles all of the Binloop’s control interfaces. In addition, the Control system is responsible for configuring and controlli…

24, Alcorn McBride Binloop User’s Manual Page 14 SMPTE Mode There are 3 basic modes that the SMPTE Interface can operate in. It can be configured to Read timecode, Generate timecode, or generate timecode in reference to the Binloop’s video clocks (Generate /w V- Sync). In Read mode, th…