Rackable Systems OMNISTOR 4000f SERIES Operation & User’s Manual

104, Appendix B - Port Information Null-Modem Cable 92 Null-Modem Cable This cable is a DB-9 (female) to DB-9 (female) null-modem type, and is used to connect a VT-100 terminal (or emulation terminal) to the SES Controller Card Service port. DB-9 to DB-9 Null-Modem Cable Pin Signals 1 2 3 4 5 6 7 8 9 …

96, Chapter 6 - Maintenance Replacing the Disk I/O Card 84 protect the optics. 6 Using a flat-blade screwdriver, loosen the two captive fastener screws that secure the card. Removing the Disk I/O Card 7 Using the captive fastener screws , gently pull the card from the enclosure. 8 Note the position of…

63, Chapter 3 - Setup and Installation JBOD (OmniStor 4000F) 51 To access Loop B: connect another Fibre Channel data cable from “D2” on the first enclosure lower Disk I/O card to the daisy-chain enclosure lower Disk I/O card “D1” connector. NOTE: For additional daisy-chain enclosur…

33, Chapter 2 - Topologies and Operating Modes Single Bus Dual-Loop Mode 21 Single Bus Dual-Loop Mode The Single Bus Dual-Loop mode provides a basic single enclosure where the drive plane is configured as a continuous twelve drive single bus dual-loop FC-AL JBOD configuration. You als…

58, Chapter 3 - Setup and Installation JBOD (OmniStor 4000F) 46 Choose a hard ID address for the host HBA(s) that will not conflict with any of the drive ID ranges. NOTE: If soft addressing is used on the host HBA, most likely there will be a conflict. This will cause the drive IDs to change, sinc…

11, Rackable Systems OMNISTOR 4000f SERIES About this Manual Typographical Conventions vii Typographical Conventions The following typographical conventions are used in the user’s guide: n Menu items are displayed in the format: “Array Configuration menu, choose View Unused Drives.” n Code font will indicate literal text used…