RAD Data Communications SecFlow-4 Installation And User Manual

270, Installation and Operation Manual SecFlow-4 Ver.3.10 16-219 mapped to separate VLANs in the backbone network so that traffic within a service group reaches only the assigned end-devices. After defining a service group the user configures a security matrix with detailed security rules…

251, Installation and Operation Manual 15-200 SecFlow-4 Ver.3.10 Inform Request Successfully Resent to SNMP Manager The Discovery Mechanism To protect the user network against message reply, delay and redirection, one of the SNMP engines involved in each communication is designated t…

168, Installation and Operation Manual SecFlow-4 Ver.3.10 10-117 Command Description show port ip-access-group-standard [ NAME | <acl-number>] [in | out] [monitoring- profile [statistics [green-bps | green- fps | match-counter-bps | match-counter- fps | not-green-bps | not-gre…

232, Installation and Operation Manual SecFlow-4 Ver.3.10 13-181 no route-map Restores to default OSPF Neighbor Configuration Commands Command Description config terminal Enters the Configuration mode router Enters the Router Configuration mode ospf Enables OSPF and enters the OSPF Ro…

158, RAD Data Communications SecFlow-4 Installation and Operation Manual SecFlow-4 Ver.3.10 10-107 Command Description source_ip A.B.C.D/MASK Mandatory Defines the packet’s source-address: A.B.C.D/MASK : source IP-address/source mask. Use keyword any when source IP-address/source-mask is 0.0.0.0/255.255.255.255 (…

378, Installation and Operation Manual SecFlow-4 Ver.3.10 26-327 Example Jan 1 01:02:48 info OSPF interface 192.168.1.1 join AllSPFRouters Multicast group. 26.2 Settings and Values Severity Levels Trap level for logging should be configured per receiver (buffer, CLI console, SSH cons…