Alesis ADAT RMB Reference Manual

14, CTIAPTER 4s APPENDTCES 4.O APPENDTX lc SPECIIIGAITONS Number of Track Indicators: Front Panel Controls and Indicators: Rear Panel Controls and Connectors: Power Requirements: Dimensions(HxWxD): Weight: Shipping Weight: Accessories Induded: Optional Accessories: 32 32 drannels …

7, CHAPIER 2s HOOKUP 2.O POWER The RMB works with any AC voltage from 90 to 250 volts, 50 to 60 Hz. This eliminates the need for transformers or voltage switches. The RMB comes with a line cord for the destination to whidr the RMB is shipped. The RMB's IEC-sp…

10, Alesis ADAT RMB Place the attachment bar on the bottom of the RMB, with its arms extending towards you. Fasten the attachment bar to the RMB using the three soews rernoved in step L and the washers provided. Match up the two holes in the side of the attachment bar with the threade…

11, 4. Place the back legs against the side of the BRC as shown, lining up the holes in the legs with the hole in the attachment bar and the threaded hole in the BRC. Insert one of the remaining two screws with washers into the second hole and tighten securely. Repeat for …

12, GHAPIER 3g BASI9 OPER.A7|ON 3.O POWERIN@-UP Normally, the RMB does not need to be powered up in any order with respect to the ADATs and the BRC for it to work properly. The power switch may be found on the left side of the back of the RMB. When the RMB is powered…

15, 4.1 APPENDIX 2: TUATNITENANGE/SERYTGE TNFOR.TUATION 4.1A Cleaning Disconnect the AC cord, then use a damp cloth to dean the RMB's metal and plastic surfaces. Do not use solvents or harsh abrasives that mav harm the surfaces. 4.18 Maintenance Here are some tips for prev…